Can a circular saw cut through a 4×4?

A circular saw is one of the best means of cutting a 4×4 post. Like miter saws that measure less than 12 inches, a circular saw’s 6.5-inch or 7.25-inch blade will not cut cleanly through a 4×4. The maximum depth of most circular saws is just 2.5 inches. This means you’ll need to make two cuts.

Can a 10 inch blade cut a 4×4?

Ten-inch blades really don’t react well on 4x4s. They go dull much faster, and eventually, you won’t be able to sharpen them enough to make quality cuts in the future.

Will a 10 inch miter saw cut a 4×4?

It may surprise you to know that the answer in question to cutting 4×4 posts with a miter saw is a hard, YES! If you can give the blade more clearance, then it should be possible to get a clean single pass cut through a 4×4 post, even when utilizing a 10-inch blade.

Will a 12 miter saw cut a 4×4?

A 12” miter saw clearly has a bigger blade. This means that it can do longer cuts faster as well as wider cuts. The cutting capacity is so superior that even the cheapest 12” miter saws on the market will still cut through 4x4s faster and cleaner than the best sliding 10” miter saw.

Will a 7 1 4 miter saw cut a 4×4?

You would have to turn the 4×4 over. Blade is a 7 1/4″ diameter, same as a hand held circular saw. From the tip of the teeth to the edge of the washer (at center of blade) I get 2 7/8″. If I needed to make cuts on 4X lumber I’ll get a 10” or 12” miter saw out and run a cord.

How to use a circular saw to cut a post?

Adjust the soleplate to the deepest setting. Once you’re done, loosen the sole plate’s thumbscrew and push it toward the saw until when it stops. After it has stopped, tighten the thumbscrew. Plug the power cord of your circular saw into a socket then start sawing on one side of the post at the cut line using your saw.

How to cut a 4 x 4 post?

Measure the length you intend to cut and mark it using a speed square tool. Also, mark all the other sides of the 4 x 4 post while ensuring the lines meet at a right angle. Put the post on a pair of sawhorses and make sure the end you want to cut hangs freely on the other side. Now, clamp it to the sawhorses using a bar clamp.

How do you cut a 4×4 with a circular saw?

Contents [ show] How to Cut a 4 x 4 Post with a Circular Saw. Step One: Measure the Length You Plan to Cut Off. Step Two: Clamp the Saw Horses on a Set of Horses. Step Three: Adjust the Saw’s Sole Plate. Step Four: Plug the Saw’s Cord into a Socket. Types of Circular Saw Blades and Their Uses. Masonry Blades.

What is the best way to cut a straight edge?

So, the best thing you can do is to use a circular saw that is designed with a fine blade. You can achieve straight cuts using a saw with a fine blade, especially if you clamp in place the straight edge guide workpiece and the panel. Blades with many teeth are designed to cut soft, non-ferrous metals and different types of plastic materials.