What is the best tool to cut flooring?

The jigsaw is the best power tool to use to cut laminate floors with for a few reasons. It’s light, important because you’ll be picking it up all day. Also, the best blades are cheap.

Can I use a hand saw to cut laminate flooring?

Sawing your boards can actually be done with a regular handsaw. Make a small cut first and then saw on! It’s ideal for shortening laminate boards. Some tips to make it easier: put your saw line as close as possible to your bearing surface and don’t forget to firmly hold the piece you’re sawing off.

What happens if you don’t stagger laminate flooring?

The main problem with laminate flooring that has not been properly staggered is that it is more likely to separate from the boards it is adjoined to. In addition, in severe circumstances, the boards may lift or move out of place.

What pattern should I lay laminate flooring?

Laminate flooring should be laid in a “random” stagger pattern. The remaining piece of one row should start the next row. Each piece must be 6 inches or greater. If the remaining piece is less than 6 inches, start the row with a full piece.

How do you keep laminate from chipping when cutting?

How to Avoid Chipping Laminate Flooring When Cutting

1. Cover the finished side of a piece of laminate floor with low-tack masking tape.
2. Make a pencil mark on the unfinished-wood side of the laminate plank at the required cut length.
3. Don safety glasses.
4. Move the plank to a stable worktable with the taped side facing down.

Which side up do you cut laminate flooring?

Leave the laminate facing right-side-up and cut it with a circular saw or handsaw.

How do you cut hardwood floors for flooring?

Score and snap is the basic technique, but it must be applied in three different ways: Crosscuts are short cuts across the plank. Rip cuts are long cuts down the length of the plank. Notch cuts remove small pieces to fit flooring around door jambs, pipes and similar.

How do you cut a plank floor without damaging it?

Place the plank on a surface you won’t mind cutting on such as the subfloor or a piece of waste flooring with the bottom side up. You won’t cut through the plank, but your knife blade might contact the floor after it runs off the plank.

What are the 4 types of wood floor cuts?

4 Types of Wood Flooring Cuts. The four types of wood cuts are plain, quarter, rift and live. The cut used can depend on intended use of the wood and species of the wood, and quality of logs, and can be influenced by ways to maximize yield, emphasize grain, and avoid defects in the log.

What is the best tool for cutting vinyl floor planks?

The fine teeth will give a smooth cut and not damage the edges of the plank being cut. When it comes to versatility, the jigsaw is probably the best tool for cutting vinyl floor planks since you can do all the cuts that you need with this one tool.