Can I connect my amplifier to audio interface?

Yes, you can plug an amp in an audio interface, provided the amp has a line out. It is advisable to connect the line out to the line input on the audio interface. Also, keep the speaker cabinet connected if you are using an amp head.

How do I connect my receiver to my passive speaker?

How to Connect Passive Speakers

1. Measure the amount of speaker wire needed to connect the speakers to the power source.
2. Remove 1/2-inch of the plastic covering on each end of the speaker wire, exposing the bare wire beneath.
3. Connect one end of the speaker wire to the terminal on the back of the speakers.

Can you connect active and passive speakers?

Generally speaking: You can chain the active speakers with the amp of the passives any way you like. However you should make sure that ALL your cable-ing is XLR type and that all the pieces on the chain have inputs AND outputs of the signal.

How do you connect 4 speakers?

The easiest and a safe way to connect 4 pairs of HiFi speakers is to use a 4 zone speaker selector switch. This is relatively simple to wire, just run a wire from the central location (lounge room) to each speaker. The box should also look after any impedance matching to prevent amplifier overload.

How do I connect Focusrite Scarlett 2I2 to Behringer 1c-bk?

Question: “How do I connect Focusrite Scarlett 2i2 to a pair of passive speaker monitors (Behringer 1C-BK)?” Being that the speakers do not have their own amplifier, and the Scarlett 2i2 only outputs analog line level (around 2 volts) you need an amplifier to plug the the line level out from the 2i2 into.

How do I connect my Scarlett 2I2 to a powered monitor?

Being that the speakers do not have their own amplifier, and the Scarlett 2i2 only outputs analog line level (around 2 volts) you need an amplifier to plug the the line level out from the 2i2 into. Then connect the passive speakers to the amp using speaker wire. With a powered monitor, the amplifier is actually inside the speaker so this is easier.

Do I need Focusrite control to use 2I2 and solo interfaces?

2i2 and Solo interfaces are class compliant on Mac computers. That means they will work with the default Mac drivers and only need Focusrite Control for remote control or adjusting settings. Go to the Focusrite Downloads page. Select your Brand (Focusrite), Product Range (Scarlett), and Product Type (model).

How do I Register my Scarlett with Focusrite?

In order to get them, you’ll need to create an account and register your Scarlett. Their online registration guide is fast, but manual registration works, too. Create a Focusrite account or log in to your current account. Once logged in, go to the product registration page.