Table of Contents
Hold the lever in place for one minute to allow the water pressure to build inside the pump. Your well pump is reset when you can release the lever and it continues to run.
Locate the reset lever. (Small silver lever about 1″ long on the side of the pressure switch.)
Where is the switch on a well pump?
When a well pump fails, the issue can often be traced to one part—the pressure switch. This above-ground part located near the pressure tank is responsible for turning the pump on and off by monitoring the pressure in the system.
Why is my well pump not kicking on?
Your well pump may have stopped working due to lack of power. Sometimes resetting a breaker or replacing a fuse affected by a power surge or brownout can fix this. If the well pump circuit breaker has tripped, the well pump itself may be failing. Then switch the circuit breaker off and on.
How do you reset a well pump after a power outage?
Using your insulated pliers, in case of stray electrical current, lift the lever upward. You should hear the pump kick on. Hold this lever in the upward position until you notice the pressure gauge get up to above 30 or so. Now if you turn it loose the pump should stay on and you are back in business.
How do you tell if pressure switch on well pump is bad?
How to Tell If Your Well Pump Pressure Switch Is Bad
- Your water pressure is at or above the cut-out pressure, yet the pump doesn’t turn off.
- Your pump doesn’t turn on at the proper cut-in pressure.
- You have low water pressure even though the pump is running.
- Your pump runs, but it cycles on and off repeatedly.
How do you tell if well pump pressure switch is bad?
How do you reset or restart your water well after a power failure?
Check the Pressure Switch Some pressure switches may need to be reset after a power outage. This is usually an easy task and all you need to do is turn the lever to “auto” and hold it until the pump turns on and the pressure gauge reads 30psi.
How do you replace a well pressure switch?
Replace a pressure switch for a water well by turning off the power, disconnecting the wiring, draining the tank, removing the old switch and installing the new one. All pressure switches eventually require replacement.
How to test a well pressure switch?
Remove the metal or plastic cover from the pressure switch. You may need a screwdriver to remove a couple of screws first.
What should my well pump pressure be set at?
Private well systems are set up to run at a certain pressure per square inch (psi), which is typically 40 to 60 psi. The pump in your well is set to run at one speed, keeping the pressure in your tank at either 40 psi or 60 psi.
Where is fuel pump reset button?
Many vehicle manufacturers have designed an inertia switch that shuts off the fuel pump when a vehicle comes to a sudden stop. This inertia switch is usually located near the airbag module and has a reset button.