How do I fix Seagate External Hard Drive not detected?

Basic hardware troubleshooting steps:

1. Try connecting the drive to a different port on the computer.
2. If possible, try using a different cable.
3. Try using the drive on a different computer.
4. Verify the drive light is on.
5. Try a different power outlet.

How do I reset my Seagate Backup Plus portable drive?

Reset using the button

1. Power down the Seagate Central by unplugging it from power.
2. Wait approximately 15 seconds.
3. Power up the Seagate Central again.
4. Wait for the device to fully boot and show a steady, non-blinking green light. This takes about three to four minutes.
5. Wait until the light becomes solidly illuminated.

How do I start my Seagate Backup Plus?

Your computer must be connected to the internet to register your device and install Toolkit. Using a file manager such as Finder or File Explorer, open Backup Plus and launch Start Here Win or Start Here Mac. Enter your information and click Register.

How do I factory reset my Seagate NAS?

Seagate strongly recommends that you backup all the data from the NAS before continuing.

1. Click the Factory Default Restore button to begin the process. A prompt will report, “This restores the device back to factory default settings.
2. Click Ok. The system will reboot.

How do I restore my external hard drive to factory settings?

Click the Go menu, select Utilities from the drop-down menu, and open Disk Utility. Choose your external drive from the left sidebar, and click Erase. Give your drive a name and select the file system you want from the Format drop-down. Click Erase, and the system will reformat your drive.

How do I factory reset my Seagate external hard drive Windows 10?

Reset using the Seagate Central Assistant

1. Log in with your credentials.
2. Select the Settings tab.
3. Select the Restore button. This will restore the device settings to default values.
4. Proceed with initial setup.

How do I format an undetectable external hard drive?

Here’s how to reformat a drive that’s showing as RAW or with an Unsupported File System:

1. In Run (Windows + R), type diskmgmt.
2. Go to Disk Management, right-click the external hard drive, and select “Format”.
3. Choose a file system like NTFS or exFAT and tick “Quick format”. Click “OK” to start the formatting.

How do I format a Seagate NAS drive?

How to recover data from Seagate external hard drive on Mac?

To recover Seagate external hard drive data on Mac, follow this link External Hard Drive Data Recovery on Mac. First, open Disk Management and check the state of your external hard drive. Then, refer to appropriate solutions given below:

Does Seagate Backup Plus work with Ubuntu?

I just bought a new Seagate backup plus, 1 TB external backup drive, USB 3.0, it is working good with my windows, but when I login into my Ubuntu 12.04 it does not get detected by any way.

What to do if Seagate hard drive cannot be detected?

Solutions of Seagate hard drive cannot be detected? Solution 1. Assign drive letter for your Seagate hard drive. Sometimes, the hard drive not showing up in File Explorer… Solution 2. Detection of antivirus. If the hard disk has got infected with virus or malware, you should run anti-virus…

How to use Seagate external hard drive for disk cloning?

You can use Seagate external hard drive to backup your important data or as take it as the destination disk of your internal disk during cloning process. In most cases, you can access the Seagate external hard drive from Windows File Explorer.