Table of Contents
How much weight can drop-in anchors hold?
Technical Specifications for Drop-In Anchors
| Size | Minimum Embedment | Max. Torque |
|---|---|---|
| 3/8” | 1-9/16” | 10 ft./lbs. |
| 1/2” | 2” | 20 ft./lbs. |
| 5/8” | 2-1/2” | 30 ft./lbs. |
| 3/4” | 3-3/16” | 40 ft./lbs. |
What is a drop-in anchor setting tool?
Drop-in anchor setting tools are used to drive drop-in anchors into concrete. The end of the setting tool will be flush with the concrete surface when the anchor has been successfully inserted.
How do I install hollow set drop in anchor?
Drill a hole through the concrete into the core using a masonry bit of correct diameter and tolerance. Blow the hole clean of dust and other material. Attach setting tool or bolt and washer onto anchor and expand it by turning the hollow setting tool or bolt 3 to 4 turns.
How many pounds can a 3/8 drop-in anchor hold?
Additional Information
| Bit Size: | 1/2″ |
|---|---|
| 2000 PSI Concrete – Pull-Out (lbs.) *: | 1170 |
| Type: | Female |
| Diameter: | 3/8″ |
| Length: | 1-9/16″ |
What are the strongest concrete anchors?
What are the strongest concrete anchors? Wedge anchors are typically the strongest anchors, but not every application requires a heavy-duty anchor. Some will do just fine with a plastic wall anchor or a nail-in version.
How do you measure drop anchors?
The measured outside diameter has to be equal to the hole diameter that you’re going to drill into the concrete. The length of the drop-in anchor is essentially the minimum embedment of the diameter. The bottom of the hole is used to set the anchor.
What is a 3/8 drop-in anchor rated for?
A 3/8″ diameter threaded rod or a bolt can be inserted into it with a maximum torque of 10 ft. lbs.
How do you insert anchor bolts in concrete?
Drop-in Anchors – for use in concrete only
- The diameter of a drop-in anchor refers to the inside diameter.
- Clean the hole of any debris before continuing.
- Insert the anchor into the hole.
- Place the fixture over the drop in anchor and thread the bolt through the fixture and into the drop in anchor.
How do you use a drop in anchor setter?
Once you drop the anchor into the hole, insert the setting tool into the hole on top of the anchor. Then, strike the setting tool with a hammer until the lip of the setting tool comes in contact with the lip of the drop in anchor. This will ensure that the drop in anchor is properly set into the cement slab.
How do you attach a drop in anchor to concrete?
Then, strike the setting tool with a hammer until the lip of the setting tool comes in contact with the lip of the drop in anchor. This will ensure that the drop in anchor is properly set into the cement slab. After you’ve inserted the drop in anchor, you can attach your fixture or a bracket to be secured to the cement slab.
What is a drop-in anchor?
Drop-in anchors are concrete fasteners designed for use in solid concrete only. Once the fastener is set, it becomes permanent. When should I use one? If you need to permanently fasten something to concrete (not brick or block), this is a great choice.
How do you use solidsolid drop in anchor setting tool?
Solid Drop In Anchor Setting Tool is a necessary accessory for properly setting drop-in anchors. The anchor is properly expanded when the shoulder of the setting tool is flush with the top of anchor. Typical applications for a drop-in anchor are overhead applications, transformers and meters, ceiling fans, and electrical light fixtures.