How to interface GSM and GPS module with 8051?

How to Operate?

1. Initially burn the program to the 8051 microcontroller.
2. Now give the connections as per the circuit diagram.
3. Give the supply to the GPS module using adaptor.
4. Interface GPS module to the computer and open hyper terminal to check the received messages.
5. Check whether the GPS is activating or not.

How to interface GSM with microcontroller?

How to Operate GSM Interfacing with 8051 Microcontroller Circuit?

1. Initially, connect the circuit as shown in the circuit 8051 Microcontroller diagram.
2. Switch on the power supply.
3. Now send a message from any other phone to the SIM present in the GSM module.

How do you interface a GPS module with PIC microcontroller?

Steps to Interface GPS with PIC Microcontroller:- Connect the GPS module to the microcontroller using USART. Initialize the system USART in continuous receive mode, with 9600 baud rate and LCD with 4bit mode. Take two character arrays depending on the Length of Latitude and Longitude.

What is GPS interfacing?

The communication boundaries between the Global Positioning System and other systems, as well as within the GPS itself, are known as interfaces.

Where do we connect the pin of GSM module to microcontroller 8051?

We can use microcontroller’s serial port to communicate with GSM, means using PIN 10 (RXD) and 11 (TXD). First we need to connect LCD to 8051, you can learn this from here: LCD Interfacing with 8051 Microcontroller.

How does GSM module work?

A GSM modem or GSM module is a hardware device that uses GSM mobile telephone technology to provide a data link to a remote network. From the view of the mobile phone network, they are essentially identical to an ordinary mobile phone, including the need for a SIM to identify themselves to the network.

How does the 8051 GPs work?

It describes the use of GPS module or receiver to find longitude and latitude of its location.The data achieved from the GPS receiver is processed by the 8051 microcontroller to take out its values in the form of longitude and latitude. The GPS interfacing with 8051 microcontroller and the location values are shown on an LCD display.

How to interface GSM with 8051 microcontroller?

It’s very easy to interface GSM with 8051, we just need to send AT commands from microcontroller and receive response from GSM and display it on LCD. We can use microcontroller’s serial port to communicate with GSM, means using PIN 10 (RXD) and 11 (TXD).

What are the circuit connections of GPS interface with microcontroller?

The circuit connections of GPS interface with microcontroller are as follows: The MAX232 is for the serial communication. The receiver pin3 of the GPS module is connected to pin13 R1IN and the output pin of MAX 232 is connected to the RxD pin10 of the microcontroller.

Can sim900a interface with 8051 based at89s52 microcontroller?

So here, we will interface 8051 based AT89S52 microcontroller with the GSM module, SIM900A. We will also interface a 16X2 character LCD with 8051 to see the output. For a complete tutorial on interfacing LCD visit: LCD Interfacing with 8051 microcontroller.