What is runway holding point?

Definition. A designated position intended to protect a runway, an obstacle limitation surface, or an ILS/MLS critical/sensitive area at which taxiing aircraft and vehicles shall stop and hold, unless otherwise authorized by the aerodrome control tower.

What does holding mean in aviation?

In aviation, holding (or flying a hold) is a maneuver designed to delay an aircraft already in flight while keeping it within a specified airspace.

What is the holding position?

A specified location on the airfield, close to the active runway and identified by visual means, at which the position of a taxiing aircraft is maintained in accordance with air traffic control instructions. Dictionary of Military and Associated Terms.

What is holding area in airport?

A defined area on an airfield where aircraft in motion either taxiing or being towed can be held to facilitate ground movement or accommodate the queue for takeoff.

What does advise holding short mean?

Hold short means to stay off the runway if aircraft are inbound and about to land or lined up for takeoff / taking off. You hold short behind the so called hold-short-line.

What marks a runway holding position?

Runway Holding Position Markings. For runways, these markings indicate where aircraft MUST STOP when approaching a runway. They consist of four yellow lines, two solid and two dashed, spaced six or twelve inches apart, and extending across the width of the taxiway or runway.

Why would ATC issue a holding clearance?

Whenever an aircraft is cleared to a fix other than the destination airport and delay is expected, it is the responsibility of ATC to issue complete holding instructions (unless the pattern is charted), an EFC time and best estimate of any additional en route/terminal delay.

What is a hold short line?

Hold short line means a pavement marking consisting of two solid yellow stripes followed by two dashed stripes extending across the width of the taxiway or runway indicating where an aircraft is required to stop as the marking indicates the close proximity of an active runway.

What colors are runway holding position signs?

Surface Painted Holding Position Signs. Surface painted holding position signs have a red background with a white inscription and supplement the signs located at the holding position. This type of marking is normally used where the width of the holding position on the taxiway is greater than 200 feet (60 m).

What is a holding point in air traffic control?

HOLDING POINT [ICAO]− A specified location, identified by visual or other means, in the vicinity of which the position of an aircraft in flight is maintained in accordance with air traffic control clearances. Elsewhere and hold short Elsewhere for taxiing, holding point is where the intended departure will take place from a runway.

What does hold your position mean in aviation?

Hold your position is an instruction to stop right now. Some airports employ LAHSO (Land and Hold Short Operations), where a hold short line exists on the runway you are landing on. Example: Cleared to land runway 27, hold short runway 22L. Example in Boston Logan (blue circle):

How long should an aircraft stay at the holding point?

Aircraft should remain at the runway holding point until all checks are complete and the runway and the approach are seen to be clear – then make the ENTERING RUNWAY broadcast. [>>>] Each flight will get its unique ~[ ⇑].

What does hold short mean on a plane?

Hold short is the same everywhere and applies to any intersection or runway on the way to the runway/gate. Taxi to holding point A, runway 36, via A, hold short C. Here the pilot will hold where C meets A and awaits clearance to continue.