Why does my phone misbehaves while charging?

It could be a filter capacitor in the charging circuit going bad, a battery at end of life or the charging cable is too close to the screen (make sure it comes off the phone at right angles for at least 6″).

How do I fix Moto G4 ghost touch?

Workaround for Moto G4 ghost touch

1. Back up your data and do a factory reset (they will anyway at the centre) to get back to stability to start with.
2. Keep screen brightness below 50\% (Above 50\% was when mine got hot esp in bright sunshine – which is when you do it)

Where is USB settings in Moto G4 plus?

Go to Settings. Developer Options. Tap on Select USB Configuration.

Can I overcharge my Motorola phone?

The direness implicit in those imperatives may be overblown, but they’re not paranoid conspiracy dictums — you still shouldn’t overcharge your phone. That’s why you can plug your iPhone or Android phone into a charger, and revving it up to at least an 80\% charge happens fairly quickly.

Why does my phone act on its own?

It’s a common result of water or moisture getting into a display, said iFixit founder Kyle Wiens in an e-mail. He added that a digitizer can start to go bad if a phone isn’t put together correctly, either at the factory or after repair.

Can charger affect screen?

No, that won’t happen. However, charging your phone with different chargers will effect your battery life since different different chargers have different voltage and output and that affects the charging quality of your battery.

Is Ghost touch a hardware problem?

Android ghost Touch is usually not a software problem. If you’re experiencing it, it’s arguably a problem from the hardware – perhaps the screen itself. Poor charging cable or charger. This is by far the most reported cause of ghost touch on Android.

How do I enable MTP mode on my Moto G?

Motorola Moto G

1. Plug the USB cable into the phone.
2. Touch and drag the notification bar down.
3. Touch Connected as a camera.
4. Touch the desired option (e.g., Media device (MTP)).
5. The USB connection option has been changed.