Why does my trumpet valve keep sticking?

The valves are too sticky. This can occur if the oil has caused debris to loosen in the trumpet valve case. It can be fixed by pulling the valve out and thoroughly wiping it with a clean cloth. It may also be helpful to remove the bottom valve cap to clean the valve casing.

Can I use wd40 on my trumpet valves?

There’s really not a good substitute for valve oil. Valve oil is a water based lubricant, so it won’t hurt your instrument, but using oil or silicone based lubricants, like WD-40 or T-9, can eat away at the nickel in your instrument and cause serious damage.

How do you fix a sticky valve?

Let the penetrating oil soak for several minutes. Gently tap on the top of the valve springs with a small hammer. Tapping the tops of the valve springs with the hammer will sometimes free up the valve stem shaft so that it can move properly. Replace the valve covers and listen for any clicking or clacking noises.

How do you fix a stuck valve?

Can I use olive oil on my trumpet valves?

Using WD-40, mineral oil, olive oil, or other oils found in your home are not recommended for oiling trumpet valves. Although it may be tempting to use these since they are typically easily accessible, it is wise to wait until you can buy proper valve oil. These home-remedies can severely damage a brass instrument.

Can you use baby oil on trumpet valves?

Can You Use Baby Oil on a Trumpet? You can use baby oil on a trumpet, but be careful. Baby oil can act as a substitute for another lubricant after you remove stuck valves. That way, you can keep the valves from sticking again.

How do you free a stuck valve?

Hit the valve with a brass hammer, gently, trying to close it — exhaust valves always stick in the open position. This works well, but slowly. It could take days, maybe a week or longer. Keep soaking, tapping, and hitting until the valve breaks loose.

What causes stuck valves?

Stuck valves are usually caused by a build-up of deposits and/orcorrosion on the valve stem. Because the fit of the stem in theguide is so snug, it doesn’t take much build-up on the valve stemto interfere with free movement of the valve within the guide.

How do you get a stuck valve off a trumpet?

While laying the trumpet flat on a solid surface, use one hand to hold the trumpet in place, and use your dominant hand to lightly tap perpendicular to the stuck valve on the valve cap. Again, use light taps, not heavy hits as to prevent any damage to the instrument.

What happens when a trumpet gets stuck?

When your trumpet gets stuck, the music it should create doesn’t come out. Its sound might become flat and long. Sometimes the music becomes too harsh that it disturbs the listeners instead of giving pleasure. When the valves get stuck suddenly, air can’t move through it.

What happens after oiling trumpet valves?

After oiling the trumpet valves, the following problems may arise. The valves usually become sticky if the oil has loosened some desire in the trumpet valve case. To fix the problem, pull the valve out and wipe it thoroughly with a clean cloth. You will then have to oil the valve again before re-inserting it.

How do I find the number of my trumpet valves?

On the trumpet valve, you should be able to see the number of the valve (1, 2, or 3) that is stamped into the top part of the valve that holds the spring. The number 1 corresponds to the valve nearest your mouthpiece, and 3 is closest to the bell of the trumpet. If the valve in the first casing isn’t number 1, you’ve solved your problem!